Video Cabling & TVs Setup / 视频布线及电视安装

🎬 Video Cabling & TVs Team / 视频布线及电视组

Team / 小组	Members / 成员
Video Cabling & TVs / 视频布线及电视	• Keiichi 加藤圭一 🔑 • Jaturaphat (Dern) •

🇬🇧 English Instructions

Purpose
This section provides the specific setup and dismantling instructions for the Video Cabling & TVs Team. This team is responsible for setting up displays around the venue and routing SDI video cables to them.

Required References

Full Drawing Set: 📎 Complete PDF
Specific Schematics:
- 1-3 Video Equipment Layout Plan
- 1-5 Cable Pathway Plan
Event Content List: Cases VDS-1, VDS-2, VDS-3, VSC-01, VSC-02, CPS-1, CPS-3

Required Equipment Cases

VDS-1, VDS-2, VDS-3: Contains TVs, confidence monitors, and their stands.
VSC-01 & VSC-02: Contains SDI video cables, including 25m and 50m lengths.
CPS-1 & CPS-3: Contains rubber cable protectors, rubber mats, and carpet strips.

Setup Steps

1. Install TVs and Monitors First
Schematics: Page 1-3 Video Equipment Layout Plan

Install all TVs and monitors around the venue first so the team can confirm the exact locations where SDI cables need to be pulled.
Confirm each TV location before running cables.
Note: TV-3 is located in the Accounting Department.

🗺️ View Video Equipment Layout Schematic (Page 1-3)

1-3 Video Equipment Layout Plan showing video headend, LED walls, and display monitor locations / 视频设备布局图，显示视频主控、LED 屏幕及显示器位置

2. Pull SDI Cables
Schematics: Pages 1-3 Video Equipment Layout Plan, 1-5 Cable Pathway Plan

Pull and route SDI cables to the confirmed TV locations according to the schematics.
When going through the front middle seating section, follow the audio snake cable route.
Keep SDI cables neat and avoid crossing walkways unless necessary.

🗺️ View Associated Schematics (Pages 1-3, 1-5)

1-5 Cable Pathway Plan showing cable routes, control areas, and walkway cable protection points / 电缆路径图，显示线缆路线、控制区域及走道线缆保护位置

3. Install Cable Protection
Schematics: Page 1-5 Cable Pathway Plan

Use rubber cable protectors when crossing walkways.
Use carpet covers for cables running under seating areas.
Coordinate with the Audio Cabling Team so cable protection is installed neatly for both audio and video cable routes.

🗺️ View Cable Pathway Schematic (Page 1-5)

4. Secure Cabling

Cover the cabling with tape and carpet once both the audio and video cabling are completely finished.
Note: When putting carpet covers down over walkways, tape one side only. Tape the other side once the entire installation is finished.
Consider attaching a tag to each SDI cable identifying its destination if time permits.

Completion Checklist

TVs and monitors installed
TV-3 placed in the Accounting Department
SDI cables pulled to confirmed TV locations
SDI route follows audio snake cable through front middle seating section
Walkway cables protected with rubber cable protectors
Seating-area cables protected with carpet covers
Cabling secured after both audio and video cabling are completed
Keyman inspection completed

Dismantling Procedure

🇨🇳 中文说明

目的
本页面提供 视频布线及电视安装组 的具体安装和拆卸说明。该小组负责在场馆各处安装显示屏幕，并将 SDI 视频线布置连接到这些屏幕。

参考资料

完整图纸： 📎 完整 PDF 文件
相关图纸：
- 1-3 视频设备布局图
- 1-5 电缆路径图
大会设备清单： 设备箱 VDS-1, VDS-2, VDS-3, VSC-01, VSC-02, CPS-1, CPS-3

所需设备箱

VDS-1, VDS-2, VDS-3： 包含各种电视、讲台提示屏幕及其支架。
VSC-01 & VSC-02： 包含 SDI 视频线，包括 25 米和 50 米长度。
CPS-1 & CPS-3： 包含橡胶电缆盖板、橡胶垫和地毯盖板。

安装步骤

1. 首先安装电视和屏幕
图纸：1-3 视频设备布局图

首先在场馆各处安装所有电视和屏幕，这样团队就能确认 SDI 视频线需要拉到的确切位置。
拉线前确认每台电视的位置。
注意： TV-3 位于会计部。

🗺️ 查看视频设备布局图（图纸 1-3）

2. 布置 SDI 视频线
图纸：1-3 视频设备布局图、1-5 电缆路径图

根据图纸，将 SDI 视频线拉到已经确认好的电视位置。
在穿过前方中间的座位区时，请沿着主音频线的路线走线。
保持 SDI 视频线整齐，尽量避免穿过过道。

🗺️ 查看相关图纸（图纸 1-3, 1-5）

3. 安装线缆保护盖板
图纸：1-5 电缆路径图

在穿过过道时使用橡胶电缆盖板。
座位区域下方的线缆使用地毯盖板。
与音频布线组协调，确保音频和视频线缆路线都整齐地受到保护。

🗺️ 查看电缆路径图（图纸 1-5）

4. 固定线缆

等音频和视频的布线都完全结束后，用胶带和地毯把线缆盖好固定。
注意： 在过道铺设地毯盖板时，只需先用胶带固定一侧。等整个安装完成后再用胶带固定另一侧。
如果时间允许，请考虑为每根 SDI 视频线贴上标签，标明连接位置。

完成检查表

电视和屏幕已安装
TV-3 已放置在会计部
SDI 视频线已拉到确认好的电视位置
前方中间座位区的 SDI 线缆已沿主音频线路线走线
过道线缆已使用橡胶电缆盖板保护
座位区域线缆已使用地毯盖板保护
音频和视频布线完成后，线缆已固定
负责人已检查确认